Cisco Small Business WRP400 User Manual page 13

Getting to Know the WRP400
Front Panel
Cisco WRP400 User Guide
LED Description
•
Mobile network connection: If a USB modem is installed, the mobile
network connection is used as a failover when an Ethernet connection is
unavailable. The Power LED shows the status of the mobile network:
•
Flashing Orange: The WRP400 is attempting to connect to the
Internet through the mobile network connection.
•
Steady Orange: The WRP400 is connected to the Internet through
the mobile network connection.
•
Continuous Flashing Orange: The WRP400 failed to connect to the
Internet through the mobile network connection and is trying again.
•
Steady Green: If a USB device is connected, this LED behavior
indicates that the device was successfully initialized and that the
WRP400 is not using the mobile network connection. If the USB
device is removed, this LED behavior indicates that theWRP400 has
power.
Phone 1-2 (Green): The Phone 1 or 2 LED lights up and stays on
when an active line is registered to the corresponding port on the
back panel. The LED slowly flashes when voicemail messages are
waiting.
Wireless (Green): The Wireless LED lights up when the wireless
feature is enabled. It flashes when the WRP400 is actively sending or
receiving data over the network.
Ethernet 1-4 (Green): These numbered LEDs, corresponding with
the numbered ports on the back panel, serve two purposes. If the
LED is solidly lit, the WRP400 is connected to a device through that
port. It flashes to indicate network activity over that port.
Internet (Green): The Internet LED lights up and stays on when an
Internet connection is made through the Internet port. It flashes to
indicate network activity over the Internet port.
NOTE: The Power LED indicates Internet connectivity through the
mobile network connection. See the information for the Power LED in
this table.
1
11