Getting to Know the WRP400
Side Panel
Side Panel
Placement Positions
Cisco WRP400 User Guide
Reset: There are two ways to reset the WRP400 to the factory
default settings. Either press and hold the Reset button for
approximately ten seconds, or restore the defaults from the
Administration >Factory Defaults screen of the administration web
server. (The Factory Defaults screen allows you to restore the router
and voice defaults separately.)
NOTE:
Restoring the voice defaults may require your login (the
default user name and password are admin). If the defaults do not
work, contact your service provider for more information.
Stand: To place the WRP400 in a vertical position, rotate the stand 90
degrees.
There are three ways to physically install the WRP400:
•
Horizontal Placement: The WRP400 has four rubber feet on the bottom
panel. Place the WRP400 on a level surface near an electrical outlet.
•
Vertical Placement: The WRP400 has a stand on the side panel opposite to
the antenna. Rotate the stand 90 degrees, and place the WRP400 on a level
surface near an electrical outlet.
•
Wall-Mounting Placement: The WRP400 has four wall-mount slots on its
back panel.
1
13