Using The Connection Status Page - Cisco CVR100W Administration Manual

Introduction

Using the Connection Status Page

Using the Connection Status Page
Cisco CVR100W Wireless-N 300M Router Administration Guide
• Configure Wireless Security (Step 3 of 4).
Enter a unique name for your wireless network (such as MyNetwork) and
select the type of wireless security. Cisco recommends using the highest
level of security that is supported by the devices in your network.
Specify the security settings based on the selected wireless security mode,
then click Next to continue. See
information on configure the wireless security settings.
• Confirm Setup Wizard Configuration (Step 4 of 4).
You can see the summary information for all configuration. If the
configuration is correct, click Save and Exit to complete the configuration. If
you click Exit, the changes you made will be lost.
After the Setup Wizard is done, the Connection Status page appears. See
Using the Connection Status Page
The Connection Status page displays the current WAN, LAN, and WLAN status of
the CVR100W.
Field
WAN
Status
IP
Mask
Gateway
DNS
Configuring Wireless Security
for more information.
Description
Shows whether the WAN port obtains an IP address
successfully or not. If the WAN port is connected to the
Internet, the network addressing mode that you use to
connect to the Internet will be displayed.
IP address of the WAN port that is accessible from the
Internet.
Subnet mask for the WAN port.
Default gateway for the WAN port.
IP addresses for the primary DNS server and the
secondary DNS server.
1
for more
17