Copying To The Y Axis; Copying In The Reverse Direction - Brother BAS-311F-0 Instruction Manual

Chapter 3 Programming with Command Function

Copying to the Y axis

Command to be used
1. Move the needle to the desired position.
Refer to "Moving needle point" (page 123).
2. Input

Copying in the reverse direction

Command to be used
1. Move the needle to the desired position.
Refer to "Moving needle point" (page 123).
2. Input
190
Copying data to the Y axis passing the current the current needle position
from the start point or the feed point (excluding the number of feed
boundaries to be ignored) to the current needle position
.
Copying data in the reverse direction from the start point or the feed point
(excluding the number of feed boundaries to be ignored) to the current
needle position
.
Programmer