Brother BAS-311F-0 Instruction Manual page 132

3. Input the stitch length and press
3.0 mm is input in the example.
Input 030 to make the stitch length to 3.0 mm.
4. Move the work clamp with
when the needle point is at point B of the
pattern.
5. Move the work clamp with
when the needle point is at point C
of the pattern.
Point C becomes a sharp corner. The range from
points A to C is programmed.
6. Press .
To change the stitch length, specify the pitch value
before pressing
7. Move the work clamp with
when the needle point is at point D of the
pattern.
8. Repeat step 7 and create the program to point
E.
9. Press
The range from points C to E is programmed.
10. Create the program to point I in the similar
manner.
Inputting the end code
1. Press
The work clamp returns to the start position.
Saving
1. Specify the program number on the operation
panel and press the read/write switch for writing
into the floppy disk.
.
. Press
.
. Press
as in step 5.
.
. Press
Programmer
Chapter 3 Programming with Command Function
131