Creating A Circle (Zigzag Circle) By Specifying The Radius - Brother BAS-311F-0 Instruction Manual

Chapter 3 Programming with Command Function
Creating a zigzag circle (go to 6 when not creating a zigzag circle)
4. Input
5. Input the zigzag stitch length in 3 digits and press
6. Move the needle with

Creating a circle (zigzag circle) by specifying the radius

Command to be used
1. Select the sewing start position with
168
(width).
to select the second point and press
Creating a circle clockwise. Input the overlap stitch counts in
Values 0 - 9 are available for input.
Creating a circle counterclockwise. Input the overlap stitchcounts in
Values 0 - 9 are available for input.
Input this command to create a zigzag circle. Input the width of zigzag in
.
"Creating a circle (zigzag circle) by specifying 3 points" (Refer to page 165.)
Input this command to create a zigzag circle. Input the zigzag stitch length in
.
"Creating a circle (zigzag circle) specifying 3 points" (Refer to page 165.)
.
and press
Programmer
.
.
.
.