Programming
1.
Press
.
The work clamp moves to the home position and
the programmer screen is displayed.
2.
Move the work clamp with
when the needle point is at point A of the
pattern.
The first stitch (point A) is programmed.
3.
Create the program to point B.
4.
Input point B and press
Input the command symmetric to Y axis.
5.
The needle point moves slowly from point B to
point A in the right half and it is automatically
programmed.
Press
movement.
Inputting the end code
1.
Press
A.
The work clamp returns to the start position.
Saving
1.
Specify the program number on the operation
panel and press the read/write switch for writing
into the floppy disk.
Ending program
1.
Press
.
. Press
.
to
make
when needle stops at point
Programmer
Chapter 3 Programming with Command Function
fast
137