Brother BAS-311F-0 Instruction Manual page 48

4. Select with
5. Select with
6. Input the zigzag width and the stitch length and
press .
3.0 mm is input in the example.
Input 030 to make the width and the stitch length
to 3.0 mm.
To switch input between the stitch length and the
width, use .
7. Move the work clamp with
when the needle point is at point B of the
pattern.
To program curves, repeat this step.
8. Press again.
9. Press three times.
Inputting the end code
1. Select with
2. Select the end code type with
.
"111" is selected in the example. Press
work clamp returns to the first stitch (point A).
3. Press .
The work clamp returns to the home position.
and press .
and press .
. Press
and press .
and press
and the
Programmer
Chapter 2 Programming with Help Function
47