Creating A Circle (Zigzag Circle) By Specifying The Radius - Brother BAS-311E Instruction Manual

Chapter 3 Programming with Command Function
Creating a zigzag circle (go to 6 when not creating a zigzag circle)
4.
5.
6.
Command to be used
1.
166
Input
7 M
Input the zigzag stitch length in 3 digits and press
Move the needle with

Creating a circle (zigzag circle) by specifying the radius

2 3 LI LI
2 4 LI LI
M
7
M
Select the sewing start position with
(width).
to select the second point and press
Creating a circle clockwise. Input the overlap stitch counts in
Values 0 - 9 are available for input.
Creating a circle counterclockwise. Input the overlap
stitchcounts in .
Values 0 - 9 are available for input.
Input this command to create a zigzag circle. Input the width of
zigzag in .
"Creating a circle (zigzag circle) by specifying 3 points"
(Refer to page 163.)
Input this command to create a zigzag circle. Input the zigzag
stitch length in
"Creating a circle (zigzag circle) specifying 3 points"
(Refer to page 163.)
Programmer
.
M
.
and press .
L
.
L
.