To Draw A Circle By Specifying The Center Of The Circle; To Draw An Ellipse - Brother PS-300B Instruction Manual

To draw a circle by specifying the center of the circle (Shape-Center Circle,
):
1. Do one of the following:
On the Shape drop-down menu, click Center Circle.
Click the Center Circle icon
When the pointer is moved into the design area, its shape changes to
2. In the design area, specify the desired location for the center point of the circle (1 in the
figure below).
3. Specify the desired location for the second point. (This determines the radius of the
circle.) (2 in the figure below.)
To draw an ellipse (Shape-Ellipse,
1. Do one of the following:
On the Shape drop-down menu, click Ellipse.
Click the Ellipse icon
When the pointer is moved into the design area, its shape changes to
2. In the design area, draw the major axis of the ellipse by specifying two points (1 in the
figure below).
3. Specify the third point to decide the minor axis of the ellipse (2 in the figure below).
NOTE: To keep the next path of the outline vertically or horizontally, hold down the keyboard's
Shift key while moving the pointer in the design area.
The angle of a path can be adjusted in increments of 15 degrees, by holding down the
keyboard's Ctrl key while moving the pointer in the design area.
in the toolbar.
):
in the toolbar.
96/164
.
.