Other Operations; Initializing Network Settings; Using Dhcp - Oki MB441MFP User Manual

Other Operations

Other Operations

This section explains how to initialize the network settings and how to setup your machine and computer
to use DHCP.

Initializing Network Settings

Note
 This procedure initializes all the network settings.
Press the <SETTING> key.
1
Press to select [Admin Setup] and
2
then press .
OK
Enter the administrator password.
3
Select [Enter] and then press
4
Press to select [Network Menu] and
5
then press .
OK
Check that [Network Setup] is selected
6
and then press
Press to select [Factory Defaults]
7
and then press
Check that [Execute] is selected and
8
then press .
OK
On the confirmation screen, press
9
to select [Yes] and then press
The network card reboots to initialize the settings.

Using DHCP

You can obtain an IP address from the DHCP
server.
Note
 You must be authorized as the administrator.
 The network system may go down if you enter an incorrect
IP address.
Memo
 You can obtain an IP address from the BOOTP server.
.
OK
.
OK
.
OK
.
OK
Configuring DHCP Server
DHCP assigns an IP address to each host on the
TCP/IP network.
Note
 The machine must have a static IP address if you want to
print via a network. For details on how to assign a static IP
address, refer to the manual of your DHCP server.
Memo
 The following OSes are supported:
- Windows Server 2008 R2, Windows Server 2008, and
Windows Server 2003
 The following steps are explained using Windows Server
2008 as an example. The steps and menus may differ
depending on the OS you use.
Click [Start] and select
1
[Administrative Tools]>[Server
Manager].
DHCP
If [
Administrative Tools
[
Select [Add Roles] on the [Roles
2
Summary] area.
On the [Add Roles Wizard], click
3
[Next].
or
Select [DHCP Server] and then click
4
[Next].
Follow the on-screen instructions and
5
configure the settings as necessary.
On the [Confirm Installation
6
Selection] screen, check the settings
and click [Install].
When the installation finishes, click
7
[Close].
Click [Start] and select
8
[Administrative Tools]>[DHCP] to
launch the [DHCP] wizard.
On the DHCP list, select a server to use.
9
From the [Action] menu, select [New
10
Scope].
- 160 -
] is already shown in
] continue to step 8.