Using Ipv6; Using Ieee802.1X - Oki MB441MFP User Manual

Changing Network Settings From the Web Page

Using IPv6

Your machine supports IPv6. The machine
obtains the IPv6 address automatically. You
cannot set the IPv6 address manually.
The machine supports the following protocols:
 For Printing:
- LPR
- IPP
- RAW (Port9100)
- FTP
 For Configuration:
- HTTP
- SNMPv1/v3
- Telnet
Operation is confirmed under specific conditions
for the following applications.
Protocol OS
LPD  Windows 7
 Windows Vista
 Windows XP
Port9100  Windows 7
 Windows Vista
FTP  Windows 7
 Windows Vista
 Windows XP
 Mac OS X
HTTP  Windows XP
 Mac OS X
Telnet  Windows 7
 Windows Vista
 Windows XP
 Mac OS X
*1) To specify a host name, edit the host's
file or access via the DNS server.
*2) On Telnet, when only IPv6 is enabled
you cannot specify a host name by the
DNS server.
*3) You cannot specify a host name when
you use a link local address to access.
*4) Enter an IPv6 address enclosed with
square brackets.
Note
 To use IPv6 on Windows XP, install IPv6.
Enabling IPv6
Access the machine's web page and log
1
in as the administrator.
Condi
Application
tion
LPR (Command *1, 2, 3
Prompt)
LPRng *1, 2, 3
FTP (Command *1, 2, 3
Prompt)
FTP (Terminal) *1, 2, 3
Internet Explorer *1, 2, 3
6.0
Safari (2.0- *1, 2,
v412.2) 3, 4
Telnet (Command *1, 2, 3
Prompt)
Telnet (Terminal) *1, 2, 3
Select [Admin Setup].
2
Select [Network]>[TCP/IP].
3
Select [Enable] for [IPv6].
4
Click [Submit].
5
The network card reboots to enable the new
settings.
Checking IPv6 Address
The OPv6 address is automatically assigned.
Select [View Info].
1
Select [Network]>[TCP/IP].
2
Memo
 When the global address is displayed only as zeros, it may
be an error due to the router being used.
Reference
 You can also check the IPv6 address in the network report
from the machine by pressing the <SETTING> key and
then selecting [Report Print] > [View Info] > [Network
Information]. For details on the report and how to print
it, refer to "Printing Reports" P.

Using IEEE802.1X

Your machine supports the IEEE802.1X
authentication.
Be sure to configure your machine and your
computer in advance before performing the
following steps.
Reference
 For details on the initial setup and the IP address, refer to
the User's Manual Basic.
Configuring Your Machine for
IEEE802.1X
 Using PEAP
Access the machine's web page and log
1
in as the administrator.
Select [Admin Setup].
2
Select [Network Manager]>
3
[IEEE802.1X].
Select [Enable] for [IEEE802.1X].
4
Select [PEAP] for [EAP Type].
5
Enter a user name in [EAP User].
6
Enter a password in [EAP Password].
7
- 156 -
72.