Multi-Sheet Bypass Feeder Entrance Sensor Actuator; Removing The Multi-Sheet Bypass Feeder Entrance Sensor Actuator - Xerox 1235DT - Phaser Color Solid Ink Printer Service Manual

Multi-sheet bypass feeder entrance sensor actuator

Warning
Switch off the power and disconnect the power cord.
1. Remove the multi-sheet bypass feeder as described in the topic on
page 127.
2.
Remove the printer unit chassis as described in the topic on page 97.
3. Remove the Tray 1 entrance sensor actuator as detailed in the topic on
page 130.
4. Remove the entrance sensor board as shown on page 113.
5.
From the bottom, squeeze the two locking tabs securing the multi-sheet
bypass feeder entrance sensor actuator.
6. Remove the actuator from the top.

Removing the multi-sheet bypass feeder entrance sensor actuator

Reverse these steps to install the multi-sheet bypass feeder entrance sensor
actuator. Ensure that the spring arm is in the notch in the frame.
Service Guide 129