Agtl+ Signal Groups Dc Specifications - Intel CELERON 1.10 GHZ Datasheet

Table 6. AGTL+ Signal Groups DC Specifications
Symbol
V
IL
V
IH
R
ON
I
L
NOTES:
1. Unless otherwise noted, all specifications in this table apply to all Celeron processor frequencies and cache
sizes.
2. V and V
IH
single system bus clock. However, input signal drivers must comply with the signal quality specifications in
Section
3. Minimum and maximum V
4. Parameter correlated to measurement into a 25
5. I for the Intel Celeron processor may experience excursions of up to 12 mA for a single system bus clock.
OH
6. (0 V
IN
packages.
7. (0 V
OUT
FC-PGA2 packages.
8. Refer to the I/O Buffer Models for IV characteristics.
9. Steady state input voltage must not be above V
Datasheet
Parameter
Input Low Voltage
• S.E.P.P and PPGA
• FC-PGA/FC-PGA2
Input High Voltage
• S.E.P.P and PPGA
• FC-PGA/FC-PGA2
Buffer On Resistance
Leakage Current for
inputs, outputs, and I/O
for the Intel Celeron processor may experience excursions of up to 200 mV above V
OH
3.0.
are given in
TT
2.0 V +5%) for S.E.P Package and PPGA Package; (0
2.0 V +5%) for S.E.P Package and PPGA Package; (0
®
Intel Celeron
Min Max
–0.3 0.82
–0.150 V – 0.200
REF
1.22 V
TT
V + 0.200 V
REF TT
16.67
±100
Table 8.
resistor terminated to 1.5 V.
V
IN
V
+ 1.65 V or below V
SS
®
Processor up to 1.10 GHz
Unit Notes
V
V 9
V 2, 3
V 2, 3
8
µA 6, 7
TT
1.5V +3%) for FC-PGA/FC-PGA2
1.5V +3%) for FC-PGA/
OUT
- 1.65 V.
TT
for a
31