Diagnostic Error Codes - IBM 8676 - Eserver xSeries 335 Hardware Maintenance Manual And Troubleshooting Manual

Note: See "System" on page 112 to determine which components should be replaced by a field service technician.
Diagnostics panel LED
DASD (The LED located next to
the drive bay that the failing drive is
installed in is lit. Check the amber
drive LED for the failing hard drive.)
PCI A (PCI/PCI-X slot 2 failed or
the integrated SCSI adapter failed.)
PCI B (An integrated Ethernet
controller or PCI/PCI-X slot 1
failed.)
PCI C (PCI/PCI-X slot 1 or the
integrated video adapter failed.)
NMI (Nonmaskable interrupt
occurred.)
NON OPT (A PCI bus is not
operating at maximum efficiency.)

Diagnostic error codes

Note: In the following error codes, if XXX is 000, 195, or 197, do not replace a
Note: See "System" on page 112 to determine which components should be replaced by a field service technician.
Error code/symptom
001-XXX-000
(Failed core tests)
001-XXX-001
(Failed core tests)
001-250-000
(Failed system board ECC)
001-250-001
(Failed processor board ECC)
005-XXX-000
(Failed video test)
011-XXX-000
(Failed COM1 serial port test)
011-XXX-001
(Failed COM2 serial port test)
84
xSeries 335 Type 8676, Type 8830: Hardware Maintenance Manual and Troubleshooting Guide
FRU/action
1. Be sure the fans are operating correctly and the airflow is good.
2. SCSI backplane.
1. Adapter
2. System board
1. Adapter
2. System board
1. Adapter
2. System board
1. Restart the server.
2. Check the System Error Log.
v Switch adapters, if possible. If adapters cannot be switched, they will
continue to operate at lowered efficiency and light will remain lit.
FRU. The description for these error codes are:
000 The test passed.
195 The Esc key was pressed to stop the test.
197 Warning; a hardware failure might not have occurred.
For all error codes, replace the FRU or take the action indicated.
FRU/action
v System board
v System board
v System board
v System board
1. Video adapter (if installed)
2. System board
v Check loopback plug connected to externalized serial port.
v Check cable from externalized port to system board.
v Check loopback plug connected to externalized serial port.
v Check cable from externalized port to system board.