IBM 8676 - Eserver xSeries 335 Hardware Maintenance Manual And Troubleshooting Manual page 64

1. Read "Safety information" on page 119 and "Installation guidelines" on page 37.
2. Turn off the server and all attached peripheral devices. Disconnect all power
3. Remove the server cover (see "Removing the cover and bezel" on page 44);
4. If you are installing a microprocessor in the microprocessor 2 socket, first install
5. Rotate the locking lever on the microprocessor socket from its closed and
54
xSeries 335 Type 8676, Type 8830: Hardware Maintenance Manual and Troubleshooting Guide
cords; then, disconnect all external signal cables from the server.
then, determine the socket where the microprocessor is to be installed.
Attention:
v Avoid touching the components and gold-edge connectors on the
microprocessor. Ensure that the microprocessor is completely and correctly
seated in the socket. Incomplete insertion might cause damage to the system
board or to the microprocessor.
v When you handle static-sensitive devices, take precautions to avoid damage
from static electricity. For information about handling these devices, see
"Handling electrostatic discharge-sensitive devices" on page 122.
Note: A new microprocessor comes in a kit with a VRM and a heat sink.
a VRM in the microprocessor 2 VRM slot (J42) and remove the protective cover
from the microprocessor 2 socket.
locked position until it stops or clicks in the fully open position (approximately
135° angle), as shown. Then, see the documentation provided with the
microprocessor option for complete installation instructions.
Attention: You must ensure that the locking lever on the microprocessor
socket is in the fully open position before you insert the microprocessor in the
socket. Failure to do so might result in permanent damage to the
microprocessor, microprocessor socket, and system board.
Lever closed
Lever closed
Note: The microprocessor-release lever is on the side of the socket that faces
the rear of the server.
Lever open
Lever open