Operator Information Panel - IBM 8676 - Eserver xSeries 335 Hardware Maintenance Manual And Troubleshooting Manual

Diskette drive activity LED: When this LED is lit, it indicates that the diskette drive
is in use.

Operator information panel

The following illustration shows the controls, LEDs and connectors on the operator
information panel.
Select LED
Select button
System-error LED: When this LED is lit, it indicates that a system error has
occurred. A system-error LED is also on the rear of the server. An LED on the Light
Path Diagnostics panel on the system board is also lit to help isolate the error.
Information LED: When this LED is lit, it indicates that a noncritical event has
occurred and is identified in the error log.
LOC (location) LED: Use this blue LED to visually locate the server if it is in a
location with numerous other servers. You can use IBM Director to light this LED
remotely.
HD (hard disk drive) activity LED: When this LED is lit, it indicates that either of
the hard disk drives is in use.
Select button: Press this button to select this server to use the monitor, keyboard,
and pointing device in a C2T chain.
Select LED: When this LED is lit, it indicates that this server is using the monitor,
keyboard, and pointing device in a C2T chain. If the server is not part of a C2T
chain, this LED remains lit. A select LED is also on the rear of the server.
System-error LED
Information LED
LOC (location) LED
HD (hard disk drive)
activity LED
Chapter 1. General information
5