Replacing The Battery - IBM 8676 - Eserver xSeries 335 Hardware Maintenance Manual And Troubleshooting Manual

5. Remove the fan from the server:
6. Position the replacement fan so that the airflow arrow on the side of the fan is
7. Position the replacement fan in the location from which you removed the failed
8. Connect the replacement fan cable to the system board, making sure that the
9. Continue with "Completing the installation" on page 59.

Replacing the battery

When replacing the battery you must replace it with a lithium battery of the same
type, from the same manufacturer. To avoid possible danger read and follow the
safety statement below.
To order replacement batteries, call 1-800-772-2227 within the United States, and
1-800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and Canada,
call your IBM reseller or IBM marketing representative.
Note: After you replace the battery, you must reconfigure your server and reset the
Statement 2:
Note: The fan LEDs are lit by the Light Path Diagnostics circuitry. For more
information about the LEDs and Light Path Diagnostics, see "Light Path
Diagnostics" on page 26 and "Light Path Diagnostic panel system error
LED" on page 82.
a. Disconnect the fan cable from the system board, noting how the cable is
routed.
b. Lift the fan out of the server.
facing or pointing toward the rear of the server.
Note: Correct airflow is from the front to the rear of the server.
fan.
cable is routed the same way as in step 5a.
system date and time.
Airflow
Chapter 4. Customer replaceable units
57