Riser card
Complete the following steps to remove the riser card.
Note:
1. Turn off the server and any attached devices.
2. Disconnect power cords and external cables from the back of the server.
3. Remove the server from the rack.
4. Remove the cover (see "Removing the cover and bezel" on page 44).
5. Remove adapters (see "Working with adapters" on page 45).
6. Pull up gently on the riser card until it detaches from the server.
To replace the riser card, reverse the preceding steps.
v Read "Installation guidelines" on page 37.
v Read the safety notices at "Safety information" on page 119.
v Read "Handling electrostatic discharge-sensitive devices" on page 122.
System board
Riser card
Chapter 5. Service replaceable units
75