Removing The Cover And Bezel - IBM 8676 - Eserver xSeries 335 Hardware Maintenance Manual And Troubleshooting Manual

Removing the cover and bezel

Complete the following steps to remove the server cover and bezel:
1. Read "Safety information" on page 119 and "Installation guidelines" on page 37.
2. Turn off the server and all attached peripheral devices. Disconnect all power
3. Remove the server from the rack.
4. Lift the cover release latch. The cover slides to the rear approximately 13 mm
5. Slide the cover back, and lift the cover off the server.
6. Press in on the USB option tray (below hard disk drive bay 1) to release it and
7. Press on the bezel retention tabs on the top, right side and bottom of the server,
To reinstall the cover and bezel, see "Installing the cover and bezel" on page 59.
44
xSeries 335 Type 8676, Type 8830: Hardware Maintenance Manual and Troubleshooting Guide
cords; then, disconnect all external signal cables from the server.
(0.5 inch).
Attention: To ensure adequate cooling and airflow, replace the cover before
turning on the server. Do not operate the server with the cover removed.
slide the tray out until it stops; then, press the retention clip at the bottom rear
of the tray and remove the tray from the server.
Note: You only need to remove the USB option tray and the bezel if you are
installing a non-hot-swap hard disk drive. It is not necessary if you are
installing other options in the server.
and pull the bezel directly away from the server.
Captive screws
Bezel retention
tabs
Bezel
retention
tabs
Retention
clip
USB option tray