IBM 8676 - Eserver xSeries 335 Hardware Maintenance Manual And Troubleshooting Manual page 134

v Disconnect the attached power cords, telecommunications systems,
v Connect and disconnect cables as described in the following table when
v Statement 2
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has
a module containing a lithium battery, replace it only with the same module
type made by the same manufacturer. The battery contains lithium and can
explode if not properly used, handled, or disposed of.
Do not:
v Throw or immerse into water
v Heat to more than 100°C (212°F)
v Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
v Statement 3
CAUTION:
When laser products (such as CD-ROMs, DVD-ROM drives, fiber optic
devices, or transmitters) are installed, note the following:
v Do not remove the covers. Removing the covers of the laser product could
v Use of controls or adjustments or performance of procedures other than
DANGER: Some laser products contain an embedded Class 3A or Class 3B
v Statement 4
124
xSeries 335 Type 8676, Type 8830: Hardware Maintenance Manual and Troubleshooting Guide
networks, and modems before you open the device covers, unless
instructed otherwise in the installation and configuration procedures.
installing, moving, or opening covers on this product or attached devices.
To Connect
1. Turn everything OFF.
2. First, attach all cables to devices.
3. Attach signal cables to connectors.
4. Attach power cords to outlet.
5. Turn device ON.
result in exposure to hazardous laser radiation. There are no serviceable
parts inside the device.
those specified herein might result in hazardous radiation exposure.
laser diode. Note the following:
Laser radiation when open. Do not stare into the beam, do not view
directly with optical instruments, and avoid direct exposure to the
beam.
To Disconnect
1. Turn everything OFF.
2. First, remove power cords from outlet.
3. Remove signal cables from connectors.
4. Remove all cables from devices.