IBM 8676 - Eserver xSeries 335 Hardware Maintenance Manual And Troubleshooting Manual page 56

v If you plan to use a RAID adapter to control internal hot-swap hard disk drives,
v If you plan to install an optional IBM Remote Supervisor Adapter, install it in
46
xSeries 335 Type 8676, Type 8830: Hardware Maintenance Manual and Troubleshooting Guide
disconnect the SCSI cable from the SCSI backplane signal connector (J8) on the
system board and connect it to the RAID adapter. The following illustration shows
the cable routing if you are installing the RAID adapter in PCI-X slot 2.
Note: See the documentation that comes with the RAID adapter for any
additional cabling instructions. That documentation also provides
information about installing the RAID software and configuring the RAID
adapter.
PCI-X slot 1. Use the ribbon cable that comes with the Remote Supervisor
Adapter to connect the 20-pin connector on the rear edge of the adapter to the
Remote Supervisor Adapter connector (J2) on the system board. For details
about installing a Remote Supervisor Adapter, see the documentation that comes
with the adapter. The following illustration shows the cable routing.
RAID adapter
SCSI cable
SCSI backplane
signal connector
(J8)
to hard disk drives
Remote Supervisor
Adapter
Cable
Remote Supervisor
Adapter connector
(J2)