Ignition Timing Check; Side Stand Ignition Cut-Off Switch - DAELIM NS125III Service Manual

Ignition System

Ignition Timing Check

NOTE
As the system uses the CDI unit, the ignition
timing need not be adjusted. Check the ignition
system if the ignition timing is incorrect.
Start and warm up the engine.
Connect the timing light to the high-tension cord.
NOTE
Read the timing light manual prior to using it.
Remove the timing hole cap from the shroud, and
start the engine.
Align the "F" mark on the rotor with the index
mark on the case when the engine is idling to
specified rpm.
Idle speed: 15 BTDC 1,800 rpm.
Gradually increase the engine speed. If the index
mark is set within the advanced "F" mark at the
engine speed greater than 3,900(rpm), it indicates
the advance system is correct.

Side Stand Ignition Cut-off Switch

Inspection
Remove the front cover.(
Remove the headlight.(
Remove the coupler of the side stand switch.
Check for continuity between the terminal as
shown below ;
ITEM TERMINAL
ON
BLACK/BLUE
(side stand
AND GREEN
is lowered)
OFF
BLACK/BLUE
(side stand
AND GREEN
is retracted)
16-6
4-3)
18-2)
SPECIFICATION
NO
CONTINUITY
CONTINUITY
Timing light
"T" mark
Hole cap