DAELIM NS125III Service Manual page 83

L. Crank Case Cover/Kick Starter/Continuously Variable Transmission
Assemble the movable driven face, guide roller
and roller pin
Assemble the seal collar.
Assemble the driven pulley, spring and clutch in
the clutch spring compressor. Compress the
assembly by turning the tool handle until the
lock nut can be installed.
Clamp the clutch spring compressor in a vise and
tighten the lock nut to the specified torque using
the lock nut wrench. Remove the spring
compressor.
Torque value: 5.5kg-m(55N.m, 40ft-lb)
Tool: - Lock nut wrench
- Clutch spring compressor
Clutch/Driven Pulley Assembly
Assemble the driven pulley to the drive shaft.
7-16
Guide roller
Lock nut wrench
Lock nut
Clutch spring compressor
Movable
driven face
Seal collar
Movable driven
face/clutch