DAELIM NS125III Service Manual page 156

If the brake bleeder is not used, do the following.
First, fill the brake fluid up to the upper limit line.
Connect the hose to the bleeder valve to receive
brake fluid.
Squeeze the brake lever completely loosen the
bleeder valve 1/2 turn, and tighten it again.
NOTE
Do not release the brake lever until the bleeder
valve is tightened.
Release the brake lever slowly to its fullest
extent, and leave it unattended for a few
seconds.
Repeat the process specified in item
until there is no more air bubbles coming out
of the bleeder valve.
Check the fluid level often, and add fluid if the
fluid level is near the lower level.
If no air leaks out of the bleeder hose, operate the
brake lever to check the presence of air.
Assemble the bleeder valve.
Torque value: 0.6kg
Add brake fluid up to upper level. Install
diaphragm and mater cylinder cap.
Torque value: 1.0kg m(10N.m, 7ft-lb)
Brake Pad
Replacement
Always replace the brake pads in pairs.
Open the lock plate tangs, and loosen the pad pin
bolt.
and
m(6N.m, 4ft-lb)
Bleeder valve
Brake hose bolt
Fixing Bolt
Brake System
Bleeder hose
Master cylinder
14-3