Dual Image - NETGEAR GSM7228PS Software Administration Manual

ProSafe 7000 Managed Switch Release 8.0.3
Web Interface: Specify the Source (Mirrored) Ports and
Destination (Probe)
1. Select Monitoring > Mirroring > Port Mirroring. A screen similar to the following
displays.
2. Scroll down and select the Source Port 1/0/2 check box. The value 1/0/2 now appears in the
Interface field at the top.
3. Enter the following information:
• In the Destination Port field, enter 1/0/3.
• In the Session Mode field, select Enable.
4. Click Apply.

Dual Image

Traditionally switches contain a single image in the permanent storage. This image is loaded
into memory every time there is a reboot. The dual image feature allows switches to have two
images in permanent storage. You can denote one of these images as an active image that
will be loaded in subsequent reboots and the other image as a backup image. This feature
provides for reduced down time for the switches, when the firmware is being upgraded or
downgraded.
The images are stored in the file system with the file names image1 and image2. These
names are used in the CLI, Web, and SNMP interfaces. Each of the images can be
associated with a textual description. The switch provides commands to associate and
retrieve the text description for an image. A switch also provides commands to activate the
backup image such that it is loaded in subsequent reboots. This activation command makes
the current active image as the backup image for subsequent reboots.
On three successive errors executing the active-image, the switch attempts to execute the
backup-image. If there are errors executing the backup-image as well, the bootloader will
invoke the boot menu.
The Dual Image feature works seamlessly with the stacking feature. All members in the stack
must be uniform in their support for the dual Image feature. The Dual Image feature works in
the following way in a Stack.
Chapter 16. Tools | 287