NETGEAR GSM7228PS Software Administration Manual page 310

After Switch B reboots:
(Netgear Switch) #show port 2/0/28
Admin
Intf Type Mode
------ ----- -------
1/0/51 Enable 10G Full 10G Full
Web Interface: Configure a Stacking Port as an Ethernet Port
1. On Switch A, configure a stack port as an Ethernet port.
a. Select System > Stacking > Advanced > Stack Port Configuration. A screen
similar to the following displays.
b. Under Stack Port Configuration, scroll down and select the 2/0/28 check box.
c. In the Configured Stack Mode list, select Ethernet.
d. Click Apply to save the settings.
2. Reboot the switch.
a. Select Maintenance > Reset > Device Reboot. A screen similar to the following
displays.
b. In the Reboot Unit No. list, select 2.
c. Click Apply.
3. On Switch B, configure a stack port as an Ethernet port
310 | Chapter 18. Switch Stacks
Physical Physical
Mode Status
-------- --------- ------
Up Enable
ProSafe 7000 Managed Switch Release 8.0.3
Link Link LACP
Status Trap Mode
------- ------
Enable long
Actor
Timeout
------