NETGEAR GSM7228PS Software Administration Manual page 427

ProSafe 7000 Managed Switch Release 8.0.3
a. Select Switching > VLAN > Advanced > VLAN Membership. A screen similar to
the following displays.
b. In the VLAN ID field, select 200.
c. Click Unit 1. The ports display.
d. Click the gray boxes under ports 4, 5, and 6 until U displays. The U specifies that
the egress packet is untagged for the port.
e. Click Apply.
3. Specify the PVID on ports 1/0/4, 1/0/5 and 1/0/6.
a. Select Switching > VLAN > Advanced > Port PVID Configuration. A screen similar
to the following displays.
b. Scroll down and select the Interface 1/0/4, 1/0/5, and 1/0/6 check boxes.
c. In the PVID (1 to 4093) field, enter 200.
d. Click Apply to save the settings.
4. Enable DHCP L2 relay on VLAN 200.
Chapter 27. DHCP L2 Relay and L3 Relay | 427