Table of Contents
Advertisement
to make the changes persistent.
8.4.8 IBM System z: ZFCP
To add further FCP-attached SCSI devices to the installed system, use the YaST ZFCP
module (Hardware > ZFCP). Select Add to add an additional device. Select the Channel
Number (adapter) from the list and specify both WWPN and FCP-LUN. Finalize the
setup by selecting Next and Close. Verify that the device has been added by checking
the output of cat /proc/scsi/scsi.
NOTE
To make the changes persistent through a reboot, run the following commands:
mkinitrd
zipl
8.4.9 Joystick
Configure a joystick connected to the sound card with Hardware > Joystick. Select
your joystick type in the list provided. If your joystick is not listed, select Generic
Analog Joystick. After selecting your joystick, make sure that it is connected then click
Test to test the functionality. Click Continue and YaST installs the required files. After
the Joystick Test window appears, test the joystick by moving it in all directions and
pressing all buttons. Each movement should be displayed in the window. If you are
satisfied with the settings, click OK to return to the module and Finish to complete
configuration.
If you have a USB device, this configuration is not necessary. Plug in the joystick and
start using it.
8.4.10 Keyboard Layout
To configure the keyboard for the console, run YaST in text mode then use Hardware
> Keyboard Layout. After clicking the module, the current layout is displayed. To
144
Installation and Administration
Advertisement
Table of Contents
Troubleshooting
