Setting Up Keyboard And Mouse - Novell LINUX ENTERPRISE DESKTOP 11 - DEPLOYMENT GUIDE 17-03-2009 Deployment Manual

4 Test the new configuration before it is applied to the system. Click Ok to decide
what to do with your configuration (Test, Save, or Cancel.)
To activate a second monitor, proceed as follows:
1 In YaST, click Hardware > Graphics Card and Monitor. SaX2 checks the system
resources and displays the Card and Monitor Properties dialog.
2 Make sure the monitor is properly detected. If not, use Change to select the ap-
propriate model from the list.
3 Enable Activate Dual Head Mode and click Configure for further tuning.
4 Make sure the second monitor is properly detected. If not, use Change to select
the appropriate model from the list.
5 Decide whether you want to use the second monitor in Cloned Multihead or in
Xinerama Multihead mode and click Ok.
6 Test the new configuration before it is applied to the system. Click Ok to decide
what to do with your configuration (Test, Save, or Cancel.)
NOTE: Restarting the X Server
Any changes you make here take effect only after you restart the X server. If
you want to restart the X server now, log out from the graphical system and
log in again.

5.3 Setting Up Keyboard and Mouse

Reconfigure input devices such as the keyboard or the mouse, or add more than one of
these devices using the YaST Keyboard and Mouse modules.
5.3.1 Keyboard Layout
In case you want to replace a standard 104-key keyboard with a multimedia keyboard
or use a different language or country layout, proceed as follows:
Setting Up Hardware Components with YaST 53