Novell LINUX ENTERPRISE SERVER 10 - INSTALLATION AND ADMINISTRATION 11-05-2007 Installation Manual page 47

3.9.5 The Expert Configuration
The Overview tab in the Installation Settings dialog provides only basic options. If you
are an advanced user and want to configure booting or change the time zone or default
runlevel, select the Expert tab. It shows the following additional entries not contained
on the Overview tab:
System
This dialog presents all the hardware information YaST could obtain about your
computer. Select any item in the list and click Details to see detailed information
about the selected item. Also add PCI IDs to device drivers with this dialog.
Add-On Products
The added source for add-on media appears in the overview. Before you start the
installation of the SUSE Linux Enterprise, add, remove, or modify add-on products
here if needed.
Booting
►zseries: This module cannot be used to configure the boot loader (zipl) on the
IBM System z platforms. ◄
During installation, YaST proposes a boot configuration for your system. Normally,
you can leave these settings unchanged. However, if you need a custom setup,
modify the proposal for your system. For information, see
uring the Boot Loader with YaST"
Time Zone
This is the same as the configuration shown earlier in installation. See
"Time Zone" (page 25) for details.
Default Runlevel
SUSE Linux Enterprise can boot to different runlevels. Normally there should be
no need to change anything here, but if necessary set the default runlevel with this
dialog. Refer to Section 19.2.3, "Configuring System Services (Runlevel) with
YaST" (page 382) for information about runlevel configuration.
(page 398).
Section 20.3, "Config-
Section 3.8,
Installation with YaST 29