Novell LINUX ENTERPRISE SERVER 10 - INSTALLATION AND ADMINISTRATION 11-05-2007 Installation Manual page 615

bind-address = ip address
If a host has several IP addresses, use this parameter to determine at which IP ad-
dress smpppd should accept connections. The default is to listen at all addresses.
host-range = min ip max ip
The parameter host-range defines a network range. Hosts whose IP addresses
are within this range are granted access to smpppd. All hosts not within this range
are denied access.
password = password
By assigning a password, limit the clients to authorized hosts. As this is a plain-
text password, you should not overrate the security it provides. If no password is
assigned, all clients are permitted to access smpppd.
slp-register = yes|no
With this parameter, the smpppd service can be announced in the network via SLP.
More information about smpppd is available in the smpppd(8) and
smpppd.conf(5) man pages.
30.7.2 Configuring KInternet, cinternet, and
qinternet for Remote Use
KInternet, cinternet, and qinternet can be used to control a local or remote smpppd.
cinternet is the command-line counterpart of the graphical KInternet. qinternet is basi-
cally the same as KInternet, but does not use the KDE libraries, so it can be used without
KDE and must be installed separately. To prepare these utilities for use with a remote
smpppd, edit the configuration file /etc/smpppd-c.conf manually or using KIn-
ternet. This file only uses three options:
sites = list of sites
Here, tell the front-ends where to search for smpppd. The front-ends test the options
in the order specified here. The local option orders the establishment of a con-
nection to the local smpppd. gateway points to an smpppd on the gateway. The
connection should be established as specified under server in config-file.
slp orders the front-ends to connect to an smpppd found via SLP.
Basic Networking 597