Novell LINUX ENTERPRISE SERVER 10 - INSTALLATION AND ADMINISTRATION 11-05-2007 Installation Manual page 963

Select 4 Start Installation or System then 3 Start Rescue System to start the rescue system.
Depending on the installation environment, you now must specify the parameters for
the network adapter and the installation source. The rescue system is loaded and the
following login prompt is shown at the end:
Skipped services in runlevel 3:
Rescue login:
You can now login as root without a password.
51.7.2 Configuring Disks
In this state, no disks are configured. You need to configure them before you can pro-
ceed.
Procedure 51.3 Configuring DASDs
1 Configure DASDs with the following command:
dasd_configure 0.0.0150 1 0
0.0.0150 is the channel to which the DASD is connected. The 1 means activate
the disk (a 0 at this place would deactivate the disk). The 0 stands for "no DIAG
mode" for the disk (a 1 here would enable DAIG access to the disk).
2 Now the DASD is online (check with cat /proc/partitions) and can
used for subsequent commands.
Procedure 51.4 Configuring a zFCP Disk
1 To configure a zFCP disk, it is necessary to first configure the zFCP adapter. Do
this with the following command:
zfcp_host_configure 0.0.4000 1
0.0.4000 is the channel to which the adapter is attached and 1 stands for acti-
vate (a 0 here would deactivate the adapter).
nfs nfsboot
Common Problems and Their Solutions 945