Novell LINUX ENTERPRISE SERVER 10 - INSTALLATION AND ADMINISTRATION 11-05-2007 Installation Manual page 589

you to load the ISDN driver as root with the command rcisdn start. On Hotplug,
used for PCMCIA or USB devices, loads the driver after the device is plugged in. When
finished with these settings, select OK.
In the next dialog, specify the interface type for your ISDN card and add ISPs to an
existing interface. Interfaces may be either the SyncPPP or the RawIP type, but most
ISPs operate in the SyncPPP mode, which is described below.
Figure 30.6 ISDN Interface Configuration
The number to enter for My Phone Number depends on your particular setup:
ISDN Card Directly Connected to Phone Outlet
A standard ISDN line provides three phone numbers (called multiple subscriber
numbers, or MSNs). If the subscriber asked for more, there may be up to 10. One
of these MSNs must be entered here, but without your area code. If you enter the
wrong number, your phone operator automatically falls back to the first MSN as-
signed to your ISDN line.
ISDN Card Connected to a Private Branch Exchange
Again, the configuration may vary depending on the equipment installed:
Basic Networking 571