Converting A New Phone From Sccp To Sip; Converting An In-Use Phone From Sccp To Sip; Converting An In-Use Phone From Sip To Sccp - Cisco CP-7942G Software Manual

Using Cisco Unified IP Phones with Different Protocols
•

Converting a New Phone from SCCP to SIP

A new, unused phone is set for SCCP by default. To convert this phone to SIP, perform these steps:
Procedure
Take one of these actions:
Step 1
•
•
•
Refer to Cisco Unified Communications Manager Administration Guide for detailed information about
Cisco Unified Communications Manager configuration. Refer to Cisco Unified Communications
Manager Bulk Administration Guide for detailed information about using BAT.
If you are not using DHCP in your network, configure the network parameters for the phone.
Step 2
See the
Save the configuration updates and reset the phone.
Step 3
Notify the user to power cycle the phone.
Step 4

Converting an In-Use Phone from SCCP to SIP

You can use the Bulk Administration Tool (BAT) to convert a phone that is in use in your network from
SCCP to SIP. To access BAT from Cisco Unified Communications Manager Administration, choose
Bulk Administration > Phones > Migrate Phones > SCCP to SIP. For detailed information, refer to
Cisco Unified Communications Manager Bulk Administration Guide.

Converting an In-Use Phone from SIP to SCCP

To convert a phone that is in use in your network from SIP to SCCP, perform these steps. For more
information, Cisco Unified Communications Manager Administration Guide.
Before deleting a SIP phone (that you want to convert to a SCCP phone) from the Cisco Unified
Tip
Communications Manager database, copy all of the phone configuration information, so when you add
the phone back to the database, you will have the configuration information readily available.
Cisco Unified IP Phone 7962G and 7942G Administration Guide for Cisco Unified Communications Manager 7.0
2-12
Deploying a Phone in an SCCP and SIP Environment, page 2-13
To auto-register the phone, set the Auto Registration Phone Protocol enterprise parameter in
Cisco Unified Communications Manager Administration to SIP.
To provision the phone by using the Bulk Administration Tool (BAT), choose the appropriate phone
model and choose SIP from BAT.
To provision the phone manually, make the appropriate changes for SIP on the Phone Configuration
window in Cisco Unified Communications Manager Administration.
"Configuring Startup Network Settings" section on page
Chapter 2 Preparing to Install the Cisco Unified IP Phone on Your Network
3-12.
OL-15483-01