Converting A New Phone From Sccp To Sip; Converting An In-Use Phone From Sccp To Sip - Cisco 7906G Administration Manual

Chapter 2 Preparing to Install the Cisco Unified IP Phone on Your Network

Converting a New Phone from SCCP to SIP

Step 1
Step 2
Step 3

Converting an In-Use Phone from SCCP to SIP

Cisco Unified IP Phone 7906G and 7911G Administration Guide for Cisco Unified CallManager 5.1
OL-11515-01
A new, unused phone is set for SCCP by default. To convert this phone to SIP,
perform these steps:
Procedure
Take one of these actions:
To auto-register the phone, set the Auto Registration Phone Protocol
•
parameter in Cisco Unified CallManager Administration to SIP.
To provision the phone using the Bulk Administration Tool (BAT), choose the
•
appropriate phone model and choose SIP from the BAT.
To provision the phone manually, make the appropriate changes for SIP on
•
the Phone Configuration page in Cisco Unified CallManager Administration.
Refer to Cisco Unified CallManager Administration Guide for more information
about Cisco Unified CallManager configuration. Refer to
Cisco Unified CallManager Bulk Administration Guide for more information
about using the BAT.
If you are not using DHCP in your network, configure the network parameters for
the phone.
See the "Configuring Startup Network Settings" section on page 3-14.
Power cycle the phone.
You can use the Bulk Administration Tool (BAT) to convert a phone that is in use
in your network from SCCP to SIP. To access BAT from
Cisco Unified CallManager Administration, choose Bulk Administration >
Phones > Migrate Phones > SCCP to SIP. For more information, refer to the
"Migrating Phones" chapter in the Cisco Unified CallManager Bulk
Administration Guide.
Using Cisco Unified IP Phones with Different Protocols
2-17