Cisco CP-7942G Software Manual page 87

Chapter 4 Configuring Settings on the Cisco Unified IP Phone
Table 4-14 Media Configuration Menu Options (continued)
Option Description
Recording Tone Indicates the length of time in milliseconds for
Duration which the beep tone plays.
If the value you configure here is less than one
third the interval, then this value overrides the
default provided by the Network Locale.
Range: 0 to 3000
Note
See also: Recording Tone
Wideband Headset Indicates whether wideband is enabled or
disabled for the headset.
Default: Disabled
Enterprise Advertise Enables/disables Cisco Unified IP Phones to
G.722 Codec advertise the G.722 codec to Cisco Unified
Communications Manager. If enabled (default),
and if each endpoint in the attempted call supports
G.722 in its capabilities set, Cisco Unified
Communications Manager will choose G.722
for the call.
Note
Device Advertise Allows you to override the Enterprise Advertise
G.722 Codec G.722 Codec on a per-phone basis.
The default is "Use System Default," which
means the value configured for the Enterprise
Advertise G.722 Codec parameter gets used.
OL-15483-01
For some Network Locales that use a
complex cadence, this setting applies
only to the first beep tone.
When a phone is registered with a Cisco
Unified Communications Manager that
does not support this setting, the default
is "Disabled."
Cisco Unified IP Phone 7962G and 7942G Administration Guide for Cisco Unified Communications Manager 7.0
To Change
From Cisco Unified Communications Manager
Administration, choose Device > Phone > Phone
Configuration.
• If Wideband Headset UI Control is enabled,
you or the user can use the phone and choose
> User Preferences > Audio
Preferences > Wideband Headset.
If Wideband Headset UI Control is disabled,
•
from Cisco Unified Communications
Manager Administration, choose Device >
Phone > Phone Configuration to set this
value.
If you allowed this option to be user
Note
controllable (in the Wideband Headset UI
Control option), the user-configured value
takes precedence.
From Cisco Unified Communications Manager
Administration, choose System > Enterprise
Parameters.
From Cisco Unified Communications Manager
Administration, choose Device > Phone.
Device Configuration Menu
4-21