Cisco CP-7942G Software Manual page 72

Network Configuration Menu
Table 4-2 Network Configuration Menu Options (continued)
Option
MAC Address
Host Name
Domain Name
Operational VLAN ID
Admin. VLAN ID
SW Port Configuration
Cisco Unified IP Phone 7962G and 7942G Administration Guide for Cisco Unified Communications Manager 7.0
4-6
Description
Unique Media Access Control (MAC) address of the
phone.
Unique host name that the DHCP server assigned to the
phone.
Name of the Domain Name System (DNS) domain in
which the phone resides.
Auxiliary Virtual Local Area Network (VLAN)
configured on a Cisco Catalyst switch in which the phone
is a member.
If the phone has not received an auxiliary VLAN, this
option indicates the Administrative VLAN.
If neither the auxiliary VLAN nor the Administrative
VLAN are configured, this option is blank.
Auxiliary VLAN in which the phone is a member.
Used only if the phone does not receive an auxiliary
VLAN from the switch; otherwise it is ignored.
Speed and duplex of the network port. Valid values:
• Auto Negotiate
10 Half—10-BaseT/half duplex
•
10 Full—10-BaseT/full duplex
•
100 Half—100-BaseT/half duplex
•
100 Full—100-BaseT/full duplex
•
1000 Full—1000-BaseT/full duplex
•
If the phone is connected to a switch, configure the port
on the switch to the same speed/duplex as the phone, or
configure both to auto-negotiate.
If you change the setting of this option, you must change
the PC Port Configuration option to the same setting.
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
To Change
Display only—Cannot configure.
Display only—Cannot configure.
Unlock network configuration
1.
options.
Set the DHCP Enabled option to
2.
No.
Scroll to the Domain Name
3.
option, press the Edit softkey,
and then enter a new domain
name.
Press the Validate softkey and
4.
then press the Save softkey.
The phone obtains its Operational
VLAN ID via Cisco Discovery
Protocol (CDP) from the switch to
which the phone is attached. To
assign a VLAN ID manually, use the
Admin VLAN ID option.
Unlock network configuration
1.
options.
Scroll to the Admin. VLAN ID
2.
option, press the Edit softkey,
and then enter a new Admin
VLAN setting.
3. Press the Validate softkey and
then press the Save softkey.
1. Unlock network configuration
options.
2. Scroll to the SW Port
Configuration option and then
press the Edit softkey.
Scroll to the setting that you
3.
want and then press the Select
softkey.
Press the Save softkey.
4.
OL-15483-01