Cisco CP-7942G Software Manual page 86

Device Configuration Menu
Table 4-14 Media Configuration Menu Options (continued)
Option Description
Recording Tone Indicates whether a recording tone (often
referred to as a beep tone) is enabled or disabled
for the phone. If the recording tone option is
enabled, the phone plays the beep tone in both
directions of every call, regardless of whether
the call actually gets recorded. The beep tone
first sounds when a call is answered.
You may want to notify your users if you enable
this option.
Default: Disabled
Related Parameters:
•
•
•
Note
Recording Tone Local Indicates the loudness setting for the beep tone
Volume that is received by the party whose phone has the
Recording Tone option enabled.
This setting applies for each listening device
(handset, speakerphone, headset).
Range: 0 percent (no tone) to 100 percent (same
level as current volume setting on the phone).
Default: 100
See also: Recording Tone
Recording Tone Indicates the loudness setting for the beep tone
Remote Volume that the remote party receives. The remote party
is the party who is on a call with the party whose
phone has the Recording Tone option enabled.
Range: 0 percent to 100 percent. (0 percent is
-66 dBM and 100 percent is -3 dBM.)
Default: 84 percent (-10dBM)
See also: Recording Tone
Cisco Unified IP Phone 7962G and 7942G Administration Guide for Cisco Unified Communications Manager 7.0
4-20
Recording Tone Local Volume
Recording Tone Remote Volume
Recording Tone Duration
Other related parameters—Beep tone
frequency in hz, the length of the beep
tone (called duration), and how often
the beep tone plays (called
interval)—are defined on a per-Network
Locale basis in the xml file that defines
tones. This xml file is usually named
tones.xml or g3-tones.xml.
Chapter 4 Configuring Settings on the Cisco Unified IP Phone
To Change
From Cisco Unified Communications Manager
Administration, choose Device > Phone > Phone
Configuration.
From Cisco Unified Communications Manager
Administration, choose Device > Phone > Phone
Configuration.
From Cisco Unified Communications Manager
Administration, choose Device > Phone > Phone
Configuration.
OL-15483-01