Cisco CP-7942G Software Manual page 58

Installing the Cisco Unified IP Phone
Table 3-1 Installing the Cisco Unified IP Phone 7962G and 7942G (continued)
Task Purpose
Connect a straight-through Ethernet cable from the
5.
switch to the network port labeled 10/100 SW on the
Cisco Unified IP Phone 7962G and 7942G.
Each Cisco Unified IP Phone ships with one Ethernet
cable in the box.
You can use either Category 3/5/5e cabling for
10-Mbps connections, but you must use Category 5/5e
for 100 Mbps connections.
Connect a straight-through Ethernet cable from
6.
another network device, such as a desktop computer,
to the access port labeled 10/100 PC port on the
Cisco Unified IP Phone 7962G and 7942G.
Optional. You can connect another network device
later if you do not connect one now.
You can use either Category 3/5/5e cabling for
10-Mbps connections, but you must use Category 5/5e
for 100 Mbps connections.
Cisco Unified IP Phone 7962G and 7942G Administration Guide for Cisco Unified Communications Manager 7.0
3-6
Chapter 3
Related Topics
See the "Network and Access Ports" section on page 3-2
for guidelines.
See the "Network and Access Ports" section on page 3-2
for guidelines.
Setting Up the Cisco Unified IP Phone
OL-15483-01