Brocade Communications Systems 8 Command Reference Manual page 756

2
portLogShow
Codes used in various fields are as follows:
state
724
Tx & Rx Header words 0,1,4 (R_CTL,D_ID,S_ID,OX_ID,RX_ID) and the first payload
word.
reject FC-PH reject reason.
busy FC-PH busy reason.
ctin Argument 0 is divided into two 16-bit fields:
[A] a bit map indicating whether subsequent arguments are valid (0001
means argument 1 is valid, 0003 means arguments 1 and 2 are valid).
[B] the CT-based service command code.
Argument 1 is the first word of the CT payload, if applicable (as specified in
[A]).
Argument 2 is the second word of the CT payload, if applicable (as specified
in [A]).
ctout Argument 0 is also divided into two 16-bit fields:
[A] a bit map indicating whether subsequent arguments are valid (0001
means argument 1 is valid, 0003 means arguments 1 and 2 are valid).
[B] the CT command code indicating whether an accept (8002) or a reject
(8001).
If [B] is an accept, argument 1 and 2 represents the first and second words of
the CT payload, if applicable (as specified in [A]).
If [B] is a reject, argument 1 contains the CT reject reason and explanation
code.
errlog Error type (refer to errShow).
loopscn The meaning further depends on each loop state:
OLP Offline reason code, usually zero.
LIP Reason code for LIPs initiated by FL_Port, if the code value is 800x (x =
[1,0xc], see below), or the lower two bytes of the LIP received, if the code
value is other than 800x.
LIM Usually zero.
BMP Memory address for the loop bitmap.
OLD Usually zero.
TMO Encoded value of the state when loop initialization timed out This value is
usually equal to the first word of a loop init frame payload. Other possible
values include:
2
94
40
1 Online
LIP (req. INITIALIZING) timeout.
F0F0ARB(F0) timeout.
CLS timeout.
Fabric OS Command Reference
53-1001764-02