Brocade Communications Systems 8 Command Reference Manual page 657

fcipcircuit
Fabric OS Command Reference
53-1001764-02
--l2cos-high l2cos
Specifies the L2CoS value for High Priority Traffic. The range is 0 to 7. The
default is 0.
--l2cos-medium l2cos
Specifies the L2CoS value for Medium Priority Traffic. The range is 0 to 7.
The default is 0.
--l2cos-low l2cos
Specifies the L2CoS value for Low Priority Traffic. The range is 0 to7. The
default is 0.
--dscp-f-class dscp
Specifies the DSCP value for F-Class Traffic. The range is 0 to 63. The
default value is 0. DSCP is supported only in Fabric OS v6.4.0 and later.
--dscp-high dscp
Specifies the DSCP value for High Priority. The range is 0 to 63. The
default value is 0. DSCP is supported only in Fabric OS v6.4.0 and later.
--dscp-medium dscp
Specifies the DSCP value for Medium Priority. The range is 0 to 63. The
default value is 0. DSCP is supported only in Fabric OS v6.4.0 and later.
--dscp-low dscp
Specifies he DSCP value for Low Priority. The range is 0 to 63. The default
value is 0. DSCP is supported only in Fabric OS v6.4.0 and later.
delete tunnel_ID
Deletes the specified FCIP tunnel. This command deletes all associated
circuits created with the fciptunnel or fcipcircuit commands. Use the
portShow command to display all FCIP tunnels and their associated circuits.
Creates an FCIP circuit on an existing tunnel. Use this command to configure
additional circuits. The circuit-specific parameters are optional. The syntax for
portcfg fcipcircuit is as follows:
portcfg fcipcircuit [slot/]ve_port option circuit_ID options [arguments]
[optional_arguments]
The following options and arguments are supported with fcipcircuit:
create circuit_ID remote_ip_addr local_ip_addr comm_rate [circuit_arguments]
Creates an FCIP circuit. You must specify the following parameters when
creating an additional circuit:
circuit_ID Specifies a numeric identifier for the circuit. The circuit ID is an integer
value between 0-9 for both the Brocade FX8-24 and the Brocade 7800.
remote_ip_addr
Specifies the IP address for the remote end of the FCIP circuit.
local_ip_addr Specifies the IP address for the local end of the FCIP circuit.
The following two operands are mutually exclusive:
2
portCfg
625