Brocade Communications Systems 8 Command Reference Manual page 530

2
lsCfg
--delete
--config
restore_to_default FID
--
restore_slot_to_default slot
--
--change
498
-b | -base Creates a base logical switch on the chassis. A base logical switch
communicates among different logical switches. Legacy switches can be
connected to the base logical switch through EX_Ports, and interswitch links
(ISLs) between base logical switches enable communication among different
logical switches. This operand is optional.
-f | -force Executes the command without confirmation. This operand is optional.
Deletes a logical switch with the specified fabric ID. The specified logical
switch must exist and no ports should be configured on this partition. You
must remove all ports from the logical switch before deleting the logical
switch instance. Use the lscfg --config command to remove the ports.
FID Specifies the Fabric ID of the logical switch. This operand is required.
Configures the specified logical switch. This command assigns ports to the
logical switch specified by a given FID. The ports are removed from the
partition on which they are currently configured. This command prompts for
confirmation, indicating that the specified ports will be disabled. The
following operands are supported:
FID Specifies the fabric ID of the logical switch. This operand is required.
-slot slot1[-slot2]
Specifies the slot number or a range of slot numbers separated by a dash, for
example -slot 3-5. This operand is required.
-port port1[-port2]
Specifies the ports to be assigned to the logical switch. Provide a valid port,
or a range of ports separated by a dash, for example -port 3-8. This operand
is optional; if omitted, all ports on the specified slots are assigned.
-f | -force Executes the command without confirmation. This operand is optional.
Moves all vacant ports in the logical switch specified by FID to the default
switch. Use this command when lsCfg
switch continues to generate errors indicating that there are ports on the
switch.
Moves all ports on a specified slot to the default switch.
Changes the fabric ID of a logical switch, creates a base logical switch out of
an existing logical switch, or removes base switch properties. The -newfid and
-base operands are exclusive and may not be combined. The following
operands are supported:
FID Specifies the Fabric ID of the logical switch. This operand is required.
-n | -newfid FID
Changes the fabric ID of an existing logical switch. This command effectively
removes the logical switch from a given logical fabric and makes it part of
another logical fabric.
-b | -base Turns an existing logical switch into a base switch. When this command is
issued on a switch that is already a base switch, this command removes the
base switch properties. This command disables the current logical switch.
After making the change, you must re-enable the switch.
show displays no ports, but the
--
Fabric OS Command Reference
53-1001764-02