Brocade Communications Systems 8 Command Reference Manual page 589

2. Get name server information. Name server info shows four devices (two of which are virtual)
The configuration is as follows:
3. Add an EE monitor on port 1 between the Initiator SID and the virtual initiator DID:
Fabric OS Command Reference
53-1001764-02
connected to the Encryption Switch along with their PIDs:
EncryptionSwitch:SecurityAdmin>nsshow
{
Type Pid COS PortName
N 0a0100; 3;2f:ff:00:06:2b:0e:b3:3c;2f:ff:00:06:2b:0e:b3:3c; na
FC4s: FCP
PortSymb: [18] "SANBlaze V3.0 Port"
Fabric Port Name: 20:01:00:05:1e:53:b8:45
Permanent Port Name: 2f:ff:00:06:2b:0e:b3:3c
Port Index: 1
Share Area: No
Device Shared in Other AD: No
Redirect: Yes target
Partial: NO
N 0a0900; 3;10:00:00:06:2b:12:66:33;20:00:00:06:2b:12:66:33; na
FC4s: IPFC FCP
PortSymb: [52] "LSI7404EP-LC A.1 L3-01071-01G FW:01.03.14 Port 1"
Fabric Port Name: 20:09:00:05:1e:53:b8:45
Permanent Port Name: 10:00:00:06:2b:12:66:33
Port Index: 9
Share Area: No
Device Shared in Other AD: No
Redirect: No
Partial: NO
N 0a2001; 3;20:00:00:05:1e:53:b8:41;20:00:00:05:1e:53:b8:41; na
FC4s: FCP
PortSymb: [21] "Crypto Virtual Target"
NodeSymb: [58] "Cntr Name:st_target Tgt Port wwn:2F:FF:00:06:2B:0E:B3:3C"
Fabric Port Name: 20:20:00:05:1e:53:b8:45
Permanent Port Name: 20:00:00:05:1e:53:b8:41
Port Index: 32
Share Area: No
Device Shared in Other AD: No
Redirect: Yes virtual
N 0a2002; 3;20:01:00:05:1e:53:b8:41;20:02:00:05:1e:53:b8:41; na
FC4s: FCP
PortSymb: [24] "Crypto Virtual Initiator"
NodeSymb: [37] "Ini Port wwn: 10:00:00:00:C9:52:00:7D"
Fabric Port Name: 20:20:00:05:1e:53:b8:45
Permanent Port Name: 20:01:00:05:1e:53:b8:41
Port Index: 32
Share Area: No
Device Shared in Other AD: No
Redirect: Yes virtual
The Local Name Server has 4 entries }
Initiator ---> VT
0x01a000 0x0a2001
EncryptionSwitch:SecurityAdmin> perfaddeemonitor 1 0x0a0100 0x0a2002
End-to-End monitor number 0 added.
NodeName
VI ---> Target
0x0a2002 0x0a0100
perfAddEEMonitor
TTL(sec)
2
557