Connecting The Speakers - Denon AVR-890 Owner's Manual

ENGLISH
s Set the "Amp Assign" Mode According to the Speaker Layout
The signals output from the AVR-890's SURR. BACK/AMP ASSIGN speaker terminals can be
switched to signals of the surround mode being used (vpage 27 "Amp Assign").
Amp assign mode SURR. BACK/AMP ASSIGN
(vpage 27) Speaker connections
Normal
b Connect to the "L" speaker
Normal
terminal.
b Set "S.Back" (vpage 28)
to "1spkr".
b Set the "S.Back" setting
Normal
(vpage 28) to "None".
Front Height
Front A Bi-Amp
b For connections, see
or
"About bi-amp connections"
Front B Bi-Amp
(vpage 12).
ZONE2
(Default)

Installing/Setting the Speakers
Example of speaker installation
Surround back
speakers
Surround back
speakers
Not connected
Front Height
speakers
Front A or B
speakers
MAIN ZONE
ZONE2
speakers
(5.1)

Connecting the Speakers

Subwoofer with Front speakers
built-in amplifier A
(L)
w q
(7.1)
(6.1)
(5.1)
Protection circuit
(7.1)
If the core wires touch the rear panel and the screws
etc., or the ± sides touch each other, the protection
circuit will be activated and the power indicator will
flash red at intervals of 0.5 secs.
If the protection circuit is activated, the speaker
output is isolated, and the power supply goes to
the standby state. If the power supply is turned off,
(5.1)
after the power supply cord is withdrawn, please
confirm that speaker cable and input cable are
ZONE2
connected.
Also, if replaying large sound levels by using
a speaker having an impedance less than that
(2)
Front speakers Center
B speaker
(R) (L) (R)
w
w q w q w q
For connections of the SURR. BACK/AMP
ASSIGN speaker terminals, see "Amp Assign"
(vpage 27).
specified (eg, 4 Ω/ohms), the temperature will rise,
and the protection circuit might be activated. The
power supply will go into the standby state, and the
power indicator will flash red at 2 second intervals.
In this case, please switch off the power supply,
and wait until the AVR-890 has cooled down, and
the surrounding ventilation is good.
Even if there are no problems with the surrounding
ventilation and connections, in the event of the
protection circuit becoming activated, due to
thinking that the AVR-890 has failed, please contact
DENON Service center after switching off.
Surround
speakers
(L) (R)
q
w q w q