Denon AVR-890 Owner's Manual page 20

ENGLISH
SIRIUS Connector
• The AVR-890 is a SIRIUS Satellite Radio Ready ® receiver. You can receive SIRIUS® Satellite Radio by
connecting to the SiriusConnect Home Tuner and subscribing to the SIRIUS service.
• Plug the SIRIUS connector on the rear panel.
• Position the Home Tuner antenna near a south-facing window to receive the best signal.
For details, see "Listening to SIRIUS Satellite Radio Programs" (vpage 42, 43).
When making connections, also refer to the operating instructions of the SiriusConnect Home Tuner.
SIRIUSConnect Home Tuner
Set as necessary
Set this to change the input signal to which the input
source is assigned.
"Input Assign" (vpage 35)
NOTE
Keep the power cord unplugged until the SiriusConnect Home Tuner connection have been completed.
"SIRIUS, XM and all related marks and logos are trademarks of Sirius XM Radio Inc. and its subsidiaries.
All rights reserved. Service not available in Alaska and Hawaii."
n Positioning the Antenna
For a consistent satellite signal, the antenna must be positioned correctly. Use the following map to
determine which area you are in and position the antenna accordingly.
NORTH
q
t r
WEST
e
w
SOUTH

b When connecting
digital audio
:
Area 1 P oint the antenna toward the sky in the east,
northeast, or southeast, either through a
SKY
window or outside.
:
P oint the antenna toward the sky in the north
Area 2
or northeast, either through a window or
outside.
:
Area 3 P oint the antenna toward the sky in the north
or northwest, either through a window or
EAST
outside.
:
Area 4 P oint the antenna toward the sky in the west,
northwest, or southwest, either through a
window or outside.
HORIZON
:
Area 5 P ut the antenna outside and point it straight
up. The antenna cannot be used indoors.
Antenna terminals
Direction of broadcasting station
FM antenna
75 Ω/ohms
Coaxial cable
FM indoor antenna
(supplied)
AM outdoor antenna
Ground
n AM loop antenna assembly
1
Remove the vinyl tie and take
out the connection line.
2
Bend in the reverse direction.
3
-1 W ith the antenna
on top of any
stable surface.
Mount
3
With the antenna
-2
attached to a wall.
Installation hole Mount on wall, etc.
Connecting Devices not Equipped with HDMI terminals
AM loop
antenna
(supplied)
n Connection of AM antennas
1
Push the lever.
2
Insert the conductor.
3
Return the lever.
NOTE
• Do not connect two FM
simultaneously.
• Even if an external AM antenna is used, do not
disconnect the AM loop antenna.
• Make sure the AM loop antenna lead terminals do
not touch metal parts of the panel.
antennas