Configuring Date And Time Service - NETGEAR FVS336Gv1 - ProSafe Dual WAN Gigabit Firewall Reference Manual

ProSafe Dual WAN Gigabit Firewall with SSL & IPsec VPN FVS336G Reference Manual
To download a firmware version:
1. Go to the NETGEAR website at
2. From the Product Selection pull-down menu, choose the FVS336G.
3. Click on the desired firmware version to reach the download page. Be sure to read the release
notes on the download page before upgrading the VPN firewall's software.
To upgrade the VPN firewall's software:
1. Select Administration > Settings Backup and Firmware Upgrade from the menu.
2. Click Browse in the Router Upgrade section.
3. Locate the downloaded file and click upload. This will start the software upgrade to your VPN
firewall. The software upgrade process might take some time. At the conclusion of the
upgrade, your VPN firewall will reboot.
Warning: Do not try to go online, turn off the VPN firewall, shutdown the computer
4. After the VPN firewall has rebooted, check the firmware version in the Router Status screen to
verify that your VPN firewall now has the new firmware installed.
Note: In some cases, such as a major upgrade, it may be necessary to erase the
configuration and manually reconfigure your VPN firewall after upgrading it.
Refer to the notes on the firmware download page to find out if this is required.

Configuring Date and Time Service

Date, time and NTP server designations can be configure on the Time Zone screen. Network Time
Protocol (NTP) is a protocol that is used to synchronize computer clock times in a network of
computers.
VPN Firewall and Network Management
http://www.netgear.com/support
or do anything else to the VPN firewall until the VPN firewall finishes the
upgrade! When the Test light turns off, wait a few more seconds before
continuing.
v1.0, January 2010
and click Downloads.
8-17