NETGEAR FVS336Gv1 - ProSafe Dual WAN Gigabit Firewall Reference Manual page 111

ProSafe Dual WAN Gigabit Firewall with SSL & IPsec VPN FVS336G Reference Manual
Go to VPN > Policies to view the IKE Policies screen. (The example policies that are listed in the
List of IKE Policies table do not correspond to the IKE policies that were created using the VPN
Wizard earlier in this chapter.)
Figure 5-20
Each policy that is listed in the List of IKE Policies table contains the following data:
• Name. Uniquely identifies each IKE policy. The name is chosen by you and used for
managing your policies; it is not supplied to the remote VPN endpoint.
• Mode. Two modes are available: either Main or Aggressive.
– Main Mode is slower but more secure.
– Aggressive mode is faster but less secure. (If specifying either a FQDN or a User FQDN
name as the Local ID/Remote ID, aggressive mode is automatically selected.)
• Local ID. The IKE/ISAKMP identifier of this device. (The remote VPN must have this value
as their remote ID.)
• Remote ID. The IKE/ISAKMP identifier of the remote VPN gateway. (The remote VPN must
have this value as its Local ID.)
• Encr. Encryption algorithm used for the IKE SA. The default setting using the VPN Wizard is
3DES. (This setting must match the Remote VPN.)
• Auth. Authentication algorithm used for the IKE SA. The default setting using the VPN
Wizard is SHA1. (This setting must match the remote VPN.)
Virtual Private Networking Using IPsec
v1.0, January 2010
5-17