Dtmf Autodialer - Yaesu VX-3R Operating Manual

DTMF O
PERATION
vious stored telephone number.
7. Rotate the DIAL knob to select the first digit of the DTMF string. Selectable entries
are 1 1 1 1 1 - 9 9 9 9 9 , and A A A A A - F F F F F , with E and F representing DTMF " " and "#" tones respectively.
8. Press the [ V/M ] key momentarily to accept the first digit and move on to the second
digit of the DTMF string.
9. Repeat the previous steps until you have completed the telephone
number string.
10. If you make a mistake, press the [ BAND ] key to backspace the
cursor, then re-enter the correct digit.
11. Press the [ TXPO ] key momentarily to store the string into the DTMF memory.
12. To store another number, press the [ TXPO ] key again, then rotate the DIAL knob to
select another DTMF Memory register, and repeat this procedure.
Press the [ F/W ] key to check (monitoring) the entered telephone number.
13. When finished storing DTMF Memories, press the PTT switch to return to normal
display.
To send the telephone number:
1. Press and hold in the [ TXPO ] key for one second to enter the Set mode.
2. Rotate the DIAL knob to select Set Mode Item 26: DT A
Note: Do not forget to pull the DIAL knob to rotate the DIAL
knob.
3. Press the [ TXPO ] key to enable adjustment of this Set Mode
Item.
4. Rotate the DIAL knob to set this Item to "AUTO
5. Press the PTT switch to return to normal display.
6. Hold the PTT switch to continue transmitting during following
steps.
A. Press the [ TXPO ] key momentarily.
B. Rotate the DIAL knob to select the DTMF Memory register (CH 0
you wish to send.
C. Press the [ TXPO ] key momentarily to transmit the tone string.
Once the string begins, you may release the PTT switch, as
the transmitter will be held "on the air" until the DTMF string
is completed.
86
DTMF A
UTODIALER
AUTO AUTO AUTO." AUTO
DT A/M M M M M .
DT A DT A
DT A
CH 0 through CH 9
CH 0 CH 0
CH 0
VX-3R O
PERATING
CH 9) CH 9 CH 9
CH 9
M
ANUAL