Yaesu VX-3R Operating Manual page 121

Set Mode Item 69 [ RPT.SFT ]
Function: Sets the magnitude of the repeater Shift.
Available Values: 0.00 - 150.00 MHz (50 kHz/step)
Default: Depends on the operating band and transceiver version.
If you press the [ F/W ] key momentarily, then rotate the DIAL knob, frequency steps of 1
MHz will be selected.
Note: This Set Mode Item can select and set the function to each memory channel indi-
vidually.
Set Mode Item 70 [ RX MD ]
Function: Selects the Receiving mode.
Available Values: AUTO/N-FM/AM/W-FM
Default: AUTO (Mode automatically changes according to operating frequency.)
Note: This Set Mode Item can select and set the function to each memory channel indi-
vidually.
Set Mode Item 71 [ S SRCH ]
Function: Selects the Smart Search Sweep mode.
Available Values: SINGLE/CONT
Default: SINGLE
SINGLE: The transceiver sweeps the current band once in each direction starting on the
current frequency. All channels where activity is present (up to 15 in each direc-
tion) are loaded into the Smart Search memories. Whether or not all 31 memo-
ries are filled, the search stops after one sweep in each direction.
CONT: The transceiver makes a sweep in each direction as with the "SINGLE" mode,
but if all 31 channels are not filled after the first sweep, the radio continues
sweeping until they are all filled.
Set Mode Item 72 [ SAVERX ]
Function: Selects the Receive-mode Battery Saver interval ("sleep" ratio)
Available Values: 0.2 - 0.9S (0.1S/step) or 1.0S - 10.0S (0.5S/step)
Default: 0.2 S (1:1)
Set Mode Item 73 [ SAVETX ]
Function: Enables/Disables the Transmitter Battery Saver.
Available Values: ON/OFF
Default: OFF
Set Mode Item 74 [ SCN.LMP ]
Function: Enables/Disables the Scan lamp (while scanner is paused).
Available Values: ON/OFF
Default: ON
VX-3R O
PERATING
M
ANUAL
( M
S
ET ENU
) M
ODE
119